- 3oz Fetish Urine Sample
- Bottle with Squirt Cap
- Heat Pad
- Rubber Band
- Temperature Strip
- Heat Induction Cap
DIRECTIONS: (SINGLE USE ONLY, once opened and heated must discard after SINGLE use)
- Shake well, unscrew cap and remove foil seal (discard seal). Place bottle in the middle of your microwave for 10-15 seconds to insure temperature strip reads between 94-100 degrees F. If temperature strip doesn’t read right away don’t be alarmed, the sample is either too cold or hot, give it a few seconds, if temperature is not met reheat for 5-10 seconds to get temperature to 94-100 degrees.
- After heating, screw on flip cap provided and shake bottle to eliminate any sediment on the bottom of the bottle.
- Remove the enclosed heat pad from the plastic pouch and shake well to activate heat. Next attach heat pad with the enclosed rubber band on the side of the bottle on the opposite side the temperature strip (this will insure proper temperature reading). Leave heating pad on the bottle since it will last up to 8 hours. You can re-heat as many times as you like to meet your needs and remember a comfortable temperature is 94-100 degrees.